Skip to content

Connecting the S100 to Wi-Fi.

← Knowledge Base
Method #1: JOIN WITH WPS
  1. Press the button to open the menu. FAN MODE is displayed.
  2. Press the button until > NETWORK is displayed.
  3. Press the button to enter the NETWORK menu. WPS NOW is displayed.
  4. Press the button again to start WPS. WPS ON is displayed.
  5. Press the WPS button on your router. After about 30 seconds, the menu should countdown RESTART 10, 9, 8...
  6. The thermostat should now be joined to your Wi-Fi network*. You can verify the network name with the NETWORK / SSID 
Method #2: JOIN WITH AN ACCESS POINT
  1. Press the Menu button on the S100 to open the menu. FAN MODE is displayed.
  2. Press the Down button until > NETWORK is displayed.
  3. Press the Mode button to enter the NETWORK menu. WPS NOW is displayed.
  4. Press the Down button once. WIFI NOW is displayed.
  5. Press the Mode button to start the access point. THERM-nnnn is displayed. This label alternates with WIFI ON
  6. Use a computer or mobile device to connect to the THERM-nnnn network. You may receive a warning that you are not connected to the Internet, but this is OK for device setup.
  7. Launch a new Web browser window on your computer or mobile device to connect to the thermostat at http://192.168.10.1.
  8. Select the "Reset Wi-Fi Configuration" button to show a list of 2.4GHz wireless networks. Note that this step will clear any network previously configured on the thermostat.
  9. Choose the customer’s home network from the list, and enter the network password, then press the "Connect" button.
  10. Upon successful connection, the thermostat display will count down RESTART 10, 9, 8 ...
  11. The thermostat is now connected to the customer’s home network. 
  12. Now reconnect your computer or mobile device to its original wireless network (not THERM-nnnn) and resume installation with your original browser.

Feedback and Knowledge Base

(thinking…)